products:flipper:flipper_product_family [Strataggem Products documentation]

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

====== - Flipper ======

{{:products:flipper:stghw_00071_flipper_nrf52840_board_reva_v12.png?600|}}

===== - Product specifications =====
  * Vin: 4V-6.5V
  * LiPo battery charger included
  * Micro USB port for programming and charging

===== - Common to Bare-Metal and Arduino =====

  * [[products:flipper:flash_stk|Flashing NRF52 with slstk2010a]]
  * [[products:flipper:pinout|Pinout of the Flipper]]

===== - Use with Arduino SDK =====

  * [[products:flipper:setup_arduino_development_environment_for_flipper|Setup arduino development environment for flipper]]
  * [[products:flipper:update_arduino_bsp|Updating Strataggem's Arduino Board Support Package]]
  * [[products:flipper:arduino_bus_references|Description of Flipper communication buses and their use in Arduino IDE]]

===== - Example of Arduino code =====

==== - GPIO ====

  * [[products:flipper:arduino_use_gpio|Use Flipper GPIO with arduino]]

==== - SPI ====

  * [[products:flipper:using_sd_card_arduino|Using Flipper SD card with arduino]]

==== - I2C ====

  * [[products:flipper:adc_i2c_arduino|I2C communication with an ADC : ADS1015]]
  * [[products:flipper:sps30_i2c_arduino|I2C Communication with a particulate matter sensor : SPS30]]
  * [[products:flipper:si70_i2c_arduino|I2C Communication with a temperature/humidity sensor : SI7021]]

==== - UART ====
  * [[products:flipper:gps_uart_arduino|UART Communication between the flipper and a GPS Module : Ublox SAM-M8Q]]