| Both sides previous revision Previous revision Next revision | Previous revision |
| start [2022/08/19 13:29] – [4. Ecosignal LoRaWAN gateway] manu | start [2023/01/13 10:32] (current) – manu |
|---|
| ---- | ---- |
| |
| ===== - Kronos ===== | |
| |
| [[products:kronos|General data about the Kronos board.]] | |
| |
| ==== - RTKronos ==== | ^ <fs 150%>[[products:LoRaWAN_gateways:ecoSignal:general_ecoSignal_doc| ecoSignal LoRaWAN gateway]] </fs> ^ <fs 150%>[[products:camel:camelv1| CAMELv1]]</fs> ^ |
| | | [[products:LoRaWAN_gateways:ecoSignal:general_ecoSignal_doc|{{::micro_gateway.png?400|}}]] | [[products:camel:camelv1|{{:products:camel:camel_2021-nov-12_16h33.png?400|}}]] | |
| |
| * [[products:kronos:rtkronos:rtkronos_configuration|Configuration of RTKronos]] | \\ \\ |
| * [[products:kronos:rtkronos:unicorecomm_GPS_RTK_devboard|Unicorecomm GPS RTK devboard]] | |
| * [[products:kronos:rtkronos:rtkronos_communication_protocol|RTKronos Communication protocol]] | |
| |
| | ^ <fs 150%>[[products:kronos:kronos_family_products|Kronos Family]] </fs> ^ <fs 150%>[[products:flipper:flipper_product_family|Flipper]]</fs> ^ |
| | | [[products:kronos:kronos_family_products|{{:products:kronos.jpg?400|}}]] | [[products:flipper:flipper_product_family|{{:products:flipper:stghw_00071_flipper_nrf52840_board_reva_v12.png?400|}}]]| |
| |
| |
| ---- | * [[products:xlbee_nrf9160:xlbee_nrf9160|XLBee NRF9160]] |
| | * [[products:postman:general_postman_doc|Postman v1]] |
| ---- | |
| | |
| ===== - Flipper ===== | |
| | |
| ==== - Common to Bare-Metal and Arduino ==== | |
| | |
| * [[products:flipper:flash_stk|Flashing NRF52 with slstk2010a]] | |
| * [[products:flipper:pinout|Pinout of the Flipper]] | |
| ==== - Use with Arduino SDK ==== | |
| | |
| * [[products:flipper:setup_arduino_development_environment_for_flipper|Setup arduino development environment for flipper]] | |
| * [[products:flipper:update_arduino_bsp|Updating Strataggem's Arduino Board Support Package]] | |
| * [[products:flipper:arduino_bus_references|Description of Flipper communication buses and their use in Arduino IDE]] | |
| | |
| ==== - Example of Arduino code ==== | |
| | |
| === - GPIO === | |
| | |
| * [[products:flipper:arduino_use_gpio|Use Flipper GPIO with arduino]] | |
| | |
| === - SPI === | |
| | |
| * [[products:flipper:using_sd_card_arduino|Using Flipper SD card with arduino]] | |
| | |
| === - I2C === | |
| | |
| * [[products:flipper:adc_i2c_arduino|I2C communication with an ADC : ADS1015]] | |
| * [[products:flipper:sps30_i2c_arduino|I2C Communication with a particulate matter sensor : SPS30]] | |
| * [[products:flipper:si70_i2c_arduino|I2C Communication with a temperature/humidity sensor : SI7021]] | |
| | |
| === - UART === | |
| * [[products:flipper:gps_uart_arduino|UART Communication between the flipper and a GPS Module : Ublox SAM-M8Q]] | |
| | |
| | |
| ---- | |
| | |
| ---- | |
| | |
| ==== - XLBEE NRF9160 ==== | |
| | |
| * Use the AT project: custom_serial_lte_modem | |
| * [[products:xlbee_nrf9160:custom_serial_lte_modem__zephyr_project_on_windows|Compile custom_serial_lte_modem project on windows]] | |
| | |
| ---- | |
| | |
| ---- | |
| | |
| ===== - Postman v1 ===== | |
| | |
| * [[products:postman:general_postman_doc|General documentation for the Postman v1 product]] | |
| | |
| | |
| ---- | |
| | |
| ---- | |
| | |
| ===== - ecoSignal LoRaWAN gateway ===== | |
| | |
| {{::micro_gateway.png?200|}} | |
| | |
| [[products:LoRaWAN_gateways:ecoSignal:general_ecoSignal_doc|Documentation for the ecoSignal LoRaWAN gateway]] | |